Cutting Aspect Metal Tiles

Find answers to frequently asked questions about aspect peel and stick tiles in metal stone glass and wood.

Cutting aspect metal tiles.

Place another full tile against the wall and mark the cutting line where the tiles overlap. Use your tape measure to get the exact dimensions of the gap. Cut the tile using a utility knife with the blade held at a 45 degree angle and pressing firmly onto the tile. Cut tile on line.

Every backsplash installation starts with a dry layout. Cut all metal tiles with a blade meant for metal. Note that it is not necessary to cut through the tile but to score it deeply with the knife. Tips on cutting installing metal tile backsplash layout.

Cut the tile using the recommended cutting tools figure 9. To successfully cut your self adhesive tiles you need to know the exact size of the piece that you need. But i found it much easier to use an oscillating tool to cut it with better accuracy. Aspect says to use tin snips to cut their tiles.

Cut and install all remaining tiles using the same steps described above. Use tube adhesive for cut pieces of aspect that are less than a third of a full tile. I placed a board inter the tile and started by putting the. Bend the tile in half.

Page 3 of the aspect metal peel stick tile installation guide lists the recommended tools to cut the tiles. To fit partial tiles lay the tile to be cut exactly over the last full tile. But i decided to pick up a new set of quality tin snips. Be sure to protect your eyes from damage by using protective eyewear or safety goggles.

You should leave approximately a inch gap away from the wall. The representative from aspect that i spoke with suggested a 60 80 tooth blade that can cut through steel if you go the route of using a miter saw but they highly recommended using tin snips. This may mean a carbide blade or a diamond blade specifically. Take the cut tile to the work space and place it in its intended location ensuring it fits properly.

Step 6 hold the tile in both hands with the cut between your hands. When installing the aspect metal peel and stick backsplash tiles it will be required to cut them eventually. When you get to the edge of a room you will have a gap that needs to be covered with a partial self adhesive tile. I was skeptical because saw blades are so effective and tin snips are me powered.

This shows you how to cut them with minimal eff. Map out and mark the cut using masking tape to cover the surface of the tile.